ZMAX Variable Volt/Variable Watt APV, Rev.2 - Stainless by SmokTech
The Stainless ZMAX Rev.2 Advanced Personal Vaporizer by SmokTech is sleek, powerful, reliable, full featured and very well built. With this version, Voltage or Wattage is variable: adjust between 3.0V-6.0V or 3.0W-15.0W, using a single 18650 or two 18350 IMR batteries with an extender cap. Check atomizer resistance and battery voltage too!
The Rev. 2 Zmax has one extra menu item (see number 8 below), which enables you to switch between RMS and mean value voltage monitoring. The RMS mode is more accurate, because it samples the output Voltage repeatedly while it is powering an atomizer. It is with these measurements that the Zmax is able to adjust for heat-related Voltage drift.
With its 4 Amp output, the Zmax is sure to rock whatever device you want to run on it! This version has a blue button and blue
LED display, that can be turned off. The Zmax has a native 510 connection, so it will run 510-threaded clearomizers without an issue. To use eGo-threaded clearomizers like the Kanger T2, T3 & EVOD, you will need a eGo adapter
. Run 808 threaded devices as well, with a 510-808 adapter
Never use non-rechargeable batteries in this or any other e-cig device! Only use the recommended batteries for this unit, it's for your safety.
Choose the Make It a Kit option to get batteries and a charger at a discounted price.
Do - Display atomizer/cartomizer output voltageDu - Display battery output voltageDr - Display atomizer/cartomizer resistance
1. Uu- Voltage up
2. Ud- Voltage down
3. So- Standby / on/off
4. Uc- Battery voltage check
5. Ds- Display change / Resistance Ω/Voltage output/Voltage under load 'live'
6. Lo- LED on/off
7. Up- Voltage power (Wattage setting)
Po - Constant power (wattage) operation
Uo - Constant voltage operation
8. Change voltage calculation method, RMS or MEAn calculation
RMS - More accurate (preferred), looks like ANS on screen
MEA - Older method used by V/Zmax (hotter), looks like NEA on screen
In the event of a fault, the following error codes may appear on your ZMAX device:
LOR - Atomizer/cartomizer resistance is too low
LOU - Battery voltage is too low, replace or charge battery
WSC - Short circuit in faulty atomizer/cartomizer
The Zmax can read your output voltage, battery voltage and cartomizer / atomizer resistance.
The price listed is for the unit only, packaged in a box with easy to understand Zmax instruction manual
. << click to download it now!