New SmokTank XL - Pyrex Dual Coil Cartomizer Tank (U-DCT V2) - 1.5 ohm, 2.5ml capacity.
The U-DCT V2 is the newest version of the DCT made with pyrex glass and anodized aluminum. Designed to fit 510 threaded devices. It's great on the eGo with the addition of a DCT Cone
. These tanks are simple to use, easy to fill and less accident prone due to the special dual coil cartomizer with built in flange. This flange prevents the cartomizer from slipping out of the tank when you pull off the drip tip. This version does not have a locking ring, but it is slotted to fit the carto and prevent turning.
Different styles of eGo DCT Cones to consider for this tank are the Type A, Type C and Type D
18.2mm x 44.9mm
Two 3.2 ohm coils run in parallel giving a total resistance of approximately 1.5-1.6 ohms. These produce huge amounts of vapor and great flavor due to the larger heating area of the dual coils and have less potential to burn due to the higher individual resistance of each coil. New improved filler material is more absorbent and provides better wicking to the coils.
They are easily refilled just by sliding the carto down below the top end cap, then dripping into the tank, being careful not to fill into the carto itself. Filling with a syringe
and 18g sharp needle
is our preferred method.
You can use the XLDCT on most 510 3.7v devices.
Need a bigger tank? Check out the 6ml SmokTank
Remember to keep them WET! They may burn if you run them too dry!
Due to the nature of cartomizers, we cannot offer warranty except for DOA.