26650 Tobh Clone Rebuildable Dripping Atomizer (RDA) in Stainless - DISCONTINUED
The 26650 Tobh by Tobeco is a rebuildable dripping atomizer made of stainless steel. With a whopping 28.5mm diameter, this atty will work great with most 26650 mods on the market, like the
26650 Cronus, the
Kryptonite (pictured to the left) or the
Mars!
The 26650 Tobh is great for dual or quad coil builds. The wide base and large post holes on this atomizer can easily handle thicker wire. The top cap features heatsink fins, which work to disperse heat and prevent heat transfer. Additionally, the finned top cap has a conical interior and is easily removable for quick and easy dripping.
The 26650 Tobh has a very deep juice well, so you can vape a while without the need to drip often! This RDA also has adjustable airflow: three air holes on each side (for a total of six) can easily be adjusted to your preference by aligning the cover with the raised tabs on the base.
The 26650 Tobh has a 510 connection with a copper pin for excellent conductivity. The RDA is very easy to disassemble - simply grip and pull off the top cap and cover to reveal the build deck. This unit comes with a spare o-rings, kanthal wire and silica wick.
This unit does not come pre-installed with wick and wire and does not include a drip tip.
Size: Height 35.1mm (1.38")/Diameter : 28.5mm (1.12")
Please Note: This item does not come with an instructional manual and is not intended for inexperienced users.
Warning on rebuildable atomizers, reprinted from the ECF website:
Please note very carefully that rebuildable atomizer coils and wicks have known risks.
Rebuildables are for experts, not average or beginner vapers with no multimeter or knowledge of how to use a meter, or when a meter must be used, or how electronic devices work. These materials cannot safely be used by the inexperienced or those without basic knowledge of electronics.
1. A rebuildable coil/wick MUST be tested carefully with a meter before it is used.
2. If it is not tested it may damage the device it is used on.
3. Faulty wicks/coils WILL blow electronic devices.
4. New coil/wick units must be tested and then used first on a strong basic electrical APV such as a Silver Bullet, that will not be destroyed by a short circuit.
5. No new coil/wick assembly should be used on an electronic device until known to be safe.
6. These items destroy electronic devices if faulty. This is a known issue.
7. These items have inherent risks and may go faulty at any time even if they were originally in good working order. The owner bears the cost of equipment damaged as a result.
8. RAs, RDAs or RBAs must only be used on equipment that cannot be seriously damaged or harm the user. In practice this could mean an electrical device with a hot spring (fuse) or an electronic device that will not activate if there is a short-circuit (a dead short). Unfused devices or unprotected electronic devices will suffer damage when used with a faulty RA or RTA.
0
