Stainless Steel (SS316L) Replacement Coil Heads for Aspire Cleito Top-Filling Clearomizer -DISCONTINUED

These dual clapton sub ohm replacement coil heads are intended for the
Aspire Cleito clearomizer.
The coils are made with stainless steel (SS316L) wire and feature organic cotton wicking. Stainless steel wire means you can use these coils in Variable Wattage or Temperature Control mode. Cleito coils are maximized for optimum flavor and vapor production.
To change the coil, first ensure the Cleito tank is empty of any e-juice. Unscrew the top cap, grip the top of the coil and unscrew to remove. Alternatively, you may pull off the glass tank to make removing the coil even easier. Then, screw in a new coil into the base of the Cleito. Please, do not over-tighten the new coil when installing - finger-tight is ideal. We recommend priming any new coil by dripping a few drops of e-liquid onto the exposed cotton on the coil. And, after filling up your Cleito, set it aside for a few minutes before using. These steps will ensure the new coil is fully saturated with juice and will not burn when you fire your device.
Recommended wattage range:
0.4 ohm - 55-65W / 450-530 degrees Fahrenheit
Price is for a single (1) coil. Get a Quantity Discount when you buy 5 or more coils - view "Quantity Pricing" in the menu above.
PLEASE NOTE: Please only use the sub ohm coil with devices capable of handling sub ohm vaping! If using a mechanical mod, please only use High Drain batteries with a high amp limit; if using a variable power mod, please use High Drain batteries in a device capable of putting out 50W and higher. NEVER use sub ohm coils on an eGo battery or a device unequipped to support sub ohm coils - it is for your safety! These coils are made of stainless steel (SS316L) wire and are appropriate for use with variable power (VW) or temperature control (TC) devices. When using on a temperature control mod, please make sure you are in TC-SS316L mode or TCR mode.
Tips:
- Gurgling noise: This is a sign that there is too much liquid in the coil head, and usually occurs after a refill. The noise will disappear with continued use. If the noise persists, "dry-burn" the coil by firing your device for a few seconds at a time without inhaling.
- Please keep the tank full and never below 1/3 full of e-liquid ("topped off"). This helps maintain the "vacuum" in the tank and keeps the coil wet, so it does not burn.
- Atomizer heads have an average lifespan between 10 to 20 days, depending on usage. When the atomizer head wears down, it may begin to leak, and vapor/flavor production begin to noticeably decrease. Replace the atomizer head with a new one if available.
Please note: Due to the nature of atomizers, we cannot offer warranty, exchange or returns except if DOA.