Cartomizer/Atomizer Cleaning Kit - With 10ml Control Syringe, Luer-lock compatible w/cleaning tubes and instructions

10ml Carto/Atty Cleaner and Filler Kit Discontinued

Includes an easy to handle 10ml Control Syringe (Luer-lock needle ready) and 2 vinyl tubes (5/16" and 3/8", one hard and one soft) to connect your cartomizer/atomizer for cleaning. The tubes are countersunk on one end to help prevent rolling up the stickers on your cartomizer/atomizer.

1. Attach the top end of your carto/atty to the included connector, then push the connector onto the syringe. Now you are ready to begin cleaning.
2. Warm 1/2 cup of distilled water - you want it to be hot, but not boiling. Be sure to stay close to a sink or to have a container you can use to catch dirty stuff.
3. Insert your connected carto/atty into the cup of water and draw up the plunger on the syringe to pull hot water through the carto/atty. Empty that into the sink or a container. Do this twice to get most of the old e-juice out.
4. With the carto/atty in the water, slowly pull and push several times to wash the unit thoroughly. Be careful not to push too hard or you may blow the connector off the syringe!
5. Force the water out of the carto/atty over the sink by briskly plunging the syringe in/out 10-15 times. Finally, set the carto/atty aside and allow to dry overnight - the next day you have a clean device, ready for use!
6. For an even cleaner carto that dries quicker, instead of setting aside to dry overnight, follow up with cleaning using vodka. Fill a shot glass with vodka and pull the alcohol through the carto/atty several times (just as you did with the water). Blow out the alcohol in the sink or in a container. Using this method, you can remove any water in the carto/atty faster (without having to let it dry) - the unit is ready to be freshly filled with e-juice right away.
   
   
   Download this here