VAMO V5 Variable Volt/Variable Watt APV - Gunmetal DISCONTINUED Item
The VAMO V5 Advanced Personal Vaporizer is sleek, powerful, reliable, full featured and very well built! The VAMO V5 has the same features as the V3, but the body of the V2.
With the VAMO V5, Voltage or Wattage is variable 3.0-6.0 volts or 3.0-15.0 watts respectively, using a single 18350 IMR battery, OR, with the included extension tube, you can run a single 18650, or two 18350 IMR batteries. With the VAMO V5, you can check atomizer resistance and battery voltage too, with a long press of the small buttons.
The VAMO V5 is single mode, which provides RMS voltage monitoring. The RMS mode is more accurate because, it samples the output Voltage repeatedly while it is powering an atomizer or cartomizer.
With its 5 Amp output, the VAMO V5 has ample power to run whatever device you put on it. The buttons and settings are easy to figure out. This version has an easy to read
OLED display. The VAMO V5 has a native
510/eGo connection, so it will run
510/eGo atomizers without adapters. Run 808 threaded devices as well, with an
808-510 adapter.
Never use non-rechargeable batteries in this or any other e-cig device! Only use the recommended batteries for this unit, it's for your safety.
Choose the Make It a Kit option to get batteries and a charger at a discounted price.
How to use:
1. Click the big button 5 times to turn the unit on (or off).
2. Pressing the - button for 3 seconds displays battery voltage. Pressing the + button for 3 seconds displays the working resistance.
3. Single pressing of the +/- will increase or reduce with 0.1V or 0.5W increments depending on power mode.
4. Press and hold down the + and - buttons at the same time to enter the Menu. Once in the menu the top right or + button will advance thru the menu and the top left or - button will change that menu setting. There are only 3 function settings in the Menu.
Menu functions:
- Menu 1: Hold down both +/- buttons and it enters at Menu 1 and says Power/Voltage. Use the left button to set to either Voltage or Power output. Power output is beneficial in that regardless of your atomizer resistance, the unit will hold constant Power setting for the same vape. You forget about voltage as the unit adjusts that behind the scenes to hold the Power constant.
- Menu 2: Once in the Menu by holding +/- buttons advance to menu 2 by pressing the top right or + button. Menu 2 will say LCD Display and then pressing the top left or - button will allow you to switch what is shown on the screen while vaping. You can choose Power(voltage if set from menu 1), Resistance, or Battery. If set to power it will show your setting in Watts (or Voltage if output set to voltage) during vaping. Resistance will show the Atomizer resistance, Battery just shows the current charge of your battery.
- Menu 3: Once in menu from holding +/- press top right or + until you get to Menu 3 and it will say LCD On/Off. This menu function just allows you to turn the OLED on or off during vaping
5. Press the big button to operate the unit.
6.To turn off, click the big button 5 times.
7. Battery monitoring shuts the unit off once battery has reached end of charge.
8. LCD displays LO-O if resistance lower than 1.2ohm, LO-V if short circuit.
The price listed is for the body only, packaged in a simple box.
0
