Vapeonly Replacement Atomizer for vPipe III / Zen E-Pipe-DISCONTINUED
This replacement atomizer is intended for use with the Vapeonly vPipe III
and the Vapeonly Zen E-Pipe. The atomizer has 1.2ml
capacity and comes pre-installed with a 0.7ohm vAir-P coil
. Get one of these to replace a damaged atty on your Vapeonly e-pipe!
It is very easy to change the coil on your Vapeonly vPipe III atomizer. First, pull off the mouthpiece on your e-pipe, unscrew the atomizer and unscrew the base of the atomizer. Then, simply unscrew the old/used coil head and replace with a new one. Screw the base back onto the atomizer. Please do not over-tighten when installing a new coil.
To fill the atomizer, hold it up-side-down, unscrew the base and tilt at a slight angle. Fill with your favorite e-liquid to about the top of the center metal tube (do not get e-liquid down the center tube, it is for airflow). Then screw the base back on, screw the atomizer back into the vPipe and slide the mouthpiece back over the atomizer. When using a new coil, please allow a few minutes for the e-liquid to fully saturate the cotton wicks inside the coil before vaping. The manufacturer recommends waiting 5 minutes. This will prevent it from burning when you inhale.
this replacement atomizer can only be used with the the Vapeonly vPipe III
and the Vapeonly Zen E-Pipe. It does not come with a mouthpiece and can not be used with other vaping devices, like eGo batteries
Dimensions: Length 52.1mm (2.05") / Diameter (at the base) 16mm (0.63")